Xác định khả năng chịu lực của tiết diện thép tạo hình nguội chữ C có khoét lỗ chịu nén, uốn

Determination of sectional capacities of cold-formed steel channel sections with holes under compression or bending

  • Phạm Ngọc Hiếu
Từ khóa: Khả năng chịu lực, Tiết diện thép tạo hình nguội, Khoét lỗ, Chịu nén, uốn, Sectional capacities, Cold-formed steel sections, Holes, Under compression & bending

Tóm tắt

Cấu kiện thép tạo hình nguội thường được khoét lỗ để bố trí các hệ thống kỹ thuật trong công trình. Sự có mặt các lỗ khoét này làm giảm khả năng chịu lực của loại tiết diện này. Bài báo do đó sẽ trình bày cách xác định khả năng chịu lực của tiết diện thép chữ C tạo hình nguội có khoét lỗ chịu nén hoặc uốn sử dụng Phương pháp Cường độ trực tiếp (DSM) theo Tiêu chuẩn Mỹ AISI S100-2016. Một phần mềm phân tích mất ổn định tuyến tính phát triển bởi Viện thép và kim loại Mỹ được sử dụngđể phân tích mất ổn định tuyến tính cho tiết diện chữ C khoét lỗ. Các ví dụ tính toán được đưa ra để xác định khả năng chịu lực của tiết diện khoét lỗ và sau đó so sánh với khả năng chịu lực của tiết diện nguyên.

Abstract

Cold-formed steel members with holes are commonly used to accommodate the technical systems in the walls or ceilings. The presence of holes can lead to the reduction of their sectional capacities. This paper, therefore, presents the determination of sectional capacities of cold-formed steel channel sections under compression or bending using the Direct Strength Method (DSM) according to the Specification AISI S100-2016. An elastic buckling analysis software developed by the American Iron and Steel Institute is used to analyze elastic buckling for channel sections with holes. Examples are given for the determination of sectional capacities of channel sections with holes, which are then compared to those of gross sections.

điểm /   đánh giá
Phát hành ngày
2022-07-07