Development of Hole Recognition System from Step File

  • CF Tan
  • N Ismail
  • SV Wong
  • S Sulaiman
  • Mr Osman

Abstract

This paper describes the development of Hole Recognition System (HRS) for Computer-Aided Process Planning (CAPP) using a neutral data format produced by CAD system. The geometrical data of holes is retrieved from STandard for the Exchange of Product model data (STEP). Rule-based algorithm is used during recognising process. Current implementation of feature recognition is limited to simple hole features. Test results are presented to demonstrate the capabilities of the feature recognition algorithm. Keywords: Feature recognition; Feature; STEP file. AJSTD Vol.22(3) pp.285-295 (2005)

Tác giả

CF Tan
Department of Design and Innovation, Faculty of Mechanical Engineering, Kolej Universiti Teknikal Kebangsaan Malaysia, Ayer Keroh, Malacca, Malaysia
điểm /   đánh giá
Published
2007-07-23
Issue
Vol. 22 No. 3 (2005)
Section
Articles